TVLogic F-7H 7″ FHD HDR Field Monitor
The F-7H is a 7-inch field Full HD resolution (1920 x 1080) production monitor with ultra-high luminance of 3,600nit.
The F-7H provides SDI <-> HDMI cross conversion with 1 SDI input, 1 SDI output, 1 HDMI input and 1 HDMI output interfaces.
It also supports all the professional features such as Waveform & Vectorscope, Audio Level Meters, Focus Assist, Range Error, Time Code Display, various Aspect Ratio and Makers, 3D LUT import, Camera Logs and HDR emulation including HDR EOTFs or PQ, HLG and SLog3.
Audio Level Meter Display
Displays the level of the embedded sound signal together with the video signal input through the terminal such as SDI or HDMI.
Blue Only / Mono
Red and green channels are not used and only blue or monochrome channel is used to display the screen. This function is used to adjust the colour tones (tones and saturation) of the screen using the SMPTE colour bar. For example, after displaying the blue channel, adjust the colour (or saturation) and tint (or hue) so that the original magenta and cyan are of the same brightness, and the original grey and blue are of the same brightness.
Assigns a colour to the pixels on the boundaries of the image to inform the user to achieve the best focus. With this function, user can easily differentiate the focused area from out-focused area especially when shooting with a shallow depth of field.
H / V Delay
Allows you to check the blanking area and synchronise signals by displaying the horizontal and vertical intervals in the center of the screen.
H / V Flip
Allows the displayed image to be flipped horizontally or vertically. This feature provides flexible mounting options for camera operators.
Locks and knob or key control
Luma(Y’) Zone Check
Displays the Luma(Y’) level of the input image in colours. Each pixels Y’ analysed and changed to a certain colour or zebra pattern according to the index on the right side of the screen.
Displays various kinds of aspect ratios on the screen. Wide range or markers and security areas are available with line colour and curtain transparency selection. A user marker is available if any of standard markers fits your requirements.
Max Brightness On / Off
Displays the brightness increases from the normal up to max brightness to obtain a sharp and bright image when shooting outdoors.
Analyses the input signals Luma(Y’) and chroma information(C’) and if the input signal exceeds the designated minimum value and maximum value, the pixel shall blink. This function is to help the user to easily find out any unwanted levels of signals and for a better exposure setting.
Displays the Timecode information on the screen
Adjusts the width / height display ratio
Various Scan Modes
Controls the size of the image. Overscan: Extra area around the four edges of the image that may not be seen reliably by the viewer. Underscan: Constrains the size of the image so the monitor shows everything the camera is seeing. 1:1 pixel: Displays the original image resolution without scaling to match a certain resolution or an aspect ratio.
Waveform / Vector Scope
Waveform Y: Displays the Luma(Y’), Cb, Cr component of the input signal into waveform. Vector Scope: Displays the colour components ‘B-Y- and ‘R-Y’ of the input signals onto the X-Y axis.
Magnifies the input signal from 0% to 90%.
Applies the LUTs to the outbound Log signal. A LUT for every major camera manufacturer has been included (LOG-C, C-LOG, S-LOG 1, 2, 3 and RED Gamma 3, 4).
ARRI Alex Metadata over SDI
Takes the Metadata from the ARRI Alexa is transported through the SDI outputs of the camera, an